(Sr./Staff) ASIC Design Engineer

Key Responsibilities Key Responsibilities

RTL Design and Verification

• Develop synthesizable RTL in Verilog/SystemVerilog for custom on-chip test, monitoring, and diagnostic IP targeting analog and mixed-signal failure detection.
• Design and verify digital logic blocks such as test controllers, sequencing logic, sensor/interface control logic, measurement and monitoring logic, data capture and comparison logic, and failure detection and reporting logic.
• Build clean register and bus-connected interfaces, for example APB, AHB, or AXI-lite based control and status paths, to enable firmware interaction and subsystem integration.
• Develop testbenches, assertions, checkers, and block or subsystem-level verification environments to validate controller behavior, detection logic, configuration programming, fault response, and status reporting.
• Plan and execute functional verification for normal, corner, negative, and fault-injection scenarios, with adequate coverage of critical diagnostic behaviors.
• Collaborate with analog and mixed-signal designers to create or use behavioral models, stubs, and interface abstractions for realistic verification of failure mechanisms and observability paths.
• Debug RTL and simulation issues through waveform analysis, assertion-based checks, root-cause investigation, and close interaction with integration and product teams.
• Ensure the RTL is modular, reusable, timing-aware, synthesis-friendly, and scalable for integration across multiple SoC derivatives.

SoC Integration

• Integrate custom DFT / diagnostic IP into SoC subsystems and system-level test architecture with proper consideration for clock/reset structure, interrupt handling, and status visibility.
• Work closely with SoC integration and DFT teams to ensure compatibility with system test infrastructure, production test flows, diagnostic mechanisms, and firmware control requirements.
• Support integration readiness by addressing CDC, reset interactions, timing considerations, low-power implications, and implementation handoff requirements.

Cross-Functional Collaboration

• Work closely with digital, analog, and mixed-signal design teams, DFT engineers, SoC architects, and product/test engineering teams throughout the design and validation cycle.
• Translate analog or mixed-signal failure modes into robust digital detection logic suitable for on-chip test, screening, and diagnosis.
• Contribute to technical discussions on architecture tradeoffs, observability strategy, and practical silicon debug readiness.

Required Qualifications

• Bachelor's or Master's degree in Electrical Engineering, Computer Engineering, or a related field, with 5-7 years of relevant experience.
• Strong hands-on experience in RTL design using Verilog/SystemVerilog.
• Practical experience in RTL verification, simulation, and debugging methodologies.
• Solid understanding of ASIC / SoC design flow including coding, simulation, synthesis, and integration.
• Good foundation in digital design concepts such as FSM design, datapath design, bus protocols (AXI/AHB/APB), clock-domain handling, reset strategy, and timing considerations.
• Experience working in complex SoC environments with cross-functional teams.

Preferred Qualifications

• Experience developing control, monitoring, or diagnostic IP associated with analog or mixed-signal subsystems.
• Exposure to behavioral modeling or interface definition for analog and mixed-signal verification use cases.
• Familiarity with subsystem-level integration, production screening considerations, and silicon debug support.
• Working knowledge of scripting or automation for verification, regression, or design productivity is an advantage.