Lead Process Design Engineer

To assist the PM & other project team members to execute Detailed Engineering and FEED job in a project. Support department to establish the and Update procedures and standards

Performing Simulation studies and developing Heat & Mass Balance sheet

Flare, Blowdown & Depressurization calculations

Sizing of Equipment, Instrument and Lines

Performing Hydraulic calculation of network lines

Estimation of Power load

Preparation of Engineering documents, reports & Operating manual

Preparation of PFD, P&ID

Preparation of SAFE Charts, Cause & Effect Diagram

Preparation of Datasheets for Rotating, Static and Instruments

Guiding Project management team on emergency

Forecasting deliverables affect the schedule

• To review contract scope, prepare list of deliverables and provide inputs to planning based on budgeted manhours.

• To check and approve all documents/ deliverables using checklists and checkprints.

• To be responsible for all the technical decisions

• To ensure that work is executed on schedule and within the agreed manhours

• To initiate and discuss design changes with the FH and Project

• Manager/ Project Engineer and raise DCS (Design Change Sheet)

• To ensure that all documents/deliverables (originals and copies) and correspondence are filed (refer CP-5007).

• To ensure that the Time Sheet Procedures are followed by his teammembers.

• Plan, allocate/reallocate, monitor work and man-hours for his team members through FH.

• To anticipate and discuss any potential delays and problems, if any,with the FH and /or Project Engineering Manager/Project Engineer.

• To participate in meetings, review the minutes and incorporate the same into further work on the contract.

• To brief the FH on contract status/progress and resolve issue if any

• To ensure that all the documents/deliverables and correspondence, received from other disciplines are reviewed, responded to and/or incorporated appropriately.

• Shall update the Master list (DCI/MCI) containing records of status of all documents generated on a contract

• To co-operate with fellow Lead Engineers and Project Manager/Project Engineer for smooth execution of contracts

• Provide inputs to project manager for project closeout report and lessons learnt

• To ensure Project Quality Plan is implemented for the project.

• To coordinate with Quality for External/Internal audits and take corrective actions for any deviation from procedures.

• To ensure that the CPs/DPs and Project specific procedures are followed

• To follow Quality Objectives and maintain data

• To train the sub-ordinate and enhance the skills of team members.